#VISUAL CERTEXAM MANAGER 3.1.1 INSTALL#
#VISUAL CERTEXAM MANAGER 3.1.1 CODE#

Adjust gas pressure regulators to manufacturer and system requirementsДЈ.5В PIPING THEORYВ (13% on Exam) 3.5.1 Install Gas Piping and Tubing Systems.

Describe the purpose and operation of gas pressure regulators found in residential, commercial and institutional installations.

Size regulators based on manufacturerвЂ™s documentation and system requirements.

#VISUAL CERTEXAM MANAGER 3.1.1 CODE#

State the manufacturer, code and regulatory installation requirements for gas pressure regulators.Identify single-stage and two-stage propane regulators.Describe the installation of vent limiters (restrictors).Describe types of regulators such as service, line and appliance.Determine combustion air supply requirements such as primary, secondary, excess and dilutionДЈ.4В REGULATORS (6% on Exam) 3.4.1 Regulator Selection and Installation.Describe flue gas analysis and the equipment required.Determine flue gas composition and volumes.Describe the requirements for combustion.Determine the BTUвЂ™s required to heat water and air.Identify the products of complete combustion.Identify the products of incomplete combustion.

Describe Safety Orders, Directives and BulletinsДЈ.2В GAS PROPERTIES (5% on Exam) 3.2.1 Properties of Natural Gas and PropaneДЈ.3В COMBUSTION THEORY (5% on Exam) 3.3.1 Principles and Processes of Combustion.

Apply the Safety Standards General Regulation.

SUBJECT AREAS OF STUDY 3.1В SAFETY STANDARDS ACT AND REGULATIONS (6% on Exam) 3.1.1 Act, Regulations and Directives

an approval mark issued under section 10 of the Act ДЈ.

an appliance with an input of 120 kW or less that displays a label or mark as follows:.SCOPE OF THE CLASS B GAS FITTER CERTIFICATE OF QUALIFICATIONДЄ class B gas fitter certificate of qualification entitles the holder to perform the installation or alteration of the following gas systems under an appropriate permit: have an equivalent combination of experience and training acceptable to a provincial safety manager and have attained the standing acceptable to a provincial safety manager in a gas fitting course and examination that have been approved by a provincial safety manager.Дў.have held a gas utility certificate of qualification for at least 2 years, or.be a trainee in a gas fitting program recognized by a provincial safety manager,.be the holder of an industry training credential in plumbing, steamfitting, refrigeration or sprinkler fitting,.PREREQUISITES TO CHALLENGE THE CLASS B GAS FITTER CERTIFICATE OF QUALIFICATION EXAMINATIONДЄn applicant for a class B gas fitterвЂ™s certificate of qualification must meet the requirements of the Safety Standards Act, Safety Standards General Regulationand Gas Safety Regulation,and must:

Visual certexam manager 3.1.1